The consonants P, B, and T usually produce the worst “popping” sounds. When you speak too closely to a microphone, it captures every word you say including consonants that might be too much for the mic to bear. Use a Pop Filter A Blue Yeti microphone with a pop filter. This is ideal for one-on-one sessions like interviews. Only the front and rear parts of the microphones can capture sound. This mode allows the microphone to capture two speakers at the same. This pattern is perfect for recording a group of individuals like choir, conference calls, or group podcasts. This pattern lets the microphone capture sounds surrounding it and not just one side of it. If you’re doing monologues, podcasts, Twitch streaming, vocal recording, and instruments, then this pattern works best for those situations. This heart-shaped pattern lets you record the microphone strongly at the front and weakly at the sides. This pattern works excellently for recording acoustic guitars, choir, and ASMR videos. In this pattern, both left and right channels are active, making the sound wider and more realistic. Each of these patterns has its strengths, depending on how they are used. You can set the Blue Yeti according to four pick patterns: stereo, cardioid, omnidirectional, and bidirectional. At the front of the microphone, you can also adjust the volume of the headphones. The Blue Yeti has a 3.5 mm headphone jack that lets you monitor your recording in real-time, with no latency delays. In short, gain allows you to control the sound before processing it to refine the tone of your sound.Įxpert Tip: If you encounter distortion or feedback when recording from a loud source, just lower the mic’s sensitivity through its gain control. However, the two are completely different ideas: Volume is the output level, while the gain setting is the input level. People often get confused with gain and volume because they are used interchangeably by people. Blue Yeti mics have a “proximity effect,” emphasizing low-end frequencies like the pronounced bass in broadcasters’ voices, so maintaining the right distance is key. We recommend 6-12 inches in order to not have any undesirable sounds such as popping or hissing. DistanceĮnsure you have the proper distance between you and the Blue Yeti microphone. Since the Blue Yeti is a side-address mic, it must be in an upright position and the speaker perpendicular to it, so you can speak or sing to its sides. Once you have fixed the microphone’s position, tighten the set screws on the base. The Blue logo and headphone volume must be facing you for easy access. Place the microphone on a sturdy table or desk to keep it secure. This means you have to configure it properly to pick up an acceptable amount of noise. The microphone only has a USB connection (so no direct analog output), and it's plug-and-play in Windows 10, and I assume most other operating systems as well.As a condenser microphone, the Blue Yeti has a frequency response of 20Hz to 20kHz, which is sensitive enough to pick up even the faintest sound in the surroundings. It is certainly not a portable microphone in the sense that you can take it anywhere in your bag, but that is also not the intended use. The stand is very stable, and nice and heavy with buttons that make adjustment easy. In addition to the rotary controls, there is a clear mute button on the front, with a red light that indicates whether the microphone is on or off, and a headphone output on the bottom. A final mode is for magnified stereo recordings. A third mode is for omnidirectional, which records in all directions. Another mode is for one-on-one interviews, recording both from the front and back, but not from the sides. This together with the gain knob works great for adjusting the sound according to the environment. This mode cuts out ambient noise quite effectively so that your voice/instrument is the only thing that can be heard. Cardioid to record your own voice in a cone just in front of the microphone. One to control the gain (very useful not to have to do this in software, but directly on the device itself) in other words how 'loud' is the microphone. There's no audible latency between your recording and what you hear back, so you don't get confused by your own voice. Very handy to hear your own voice louder or softer during recordings. On the front a volume knob to control the headphone output. There are three rotary knobs on the microphone. The audio quality is top notch for a product in this price range, and the construction of the microphone is also beyond expectations. Easy to control with buttons on microphoneĭefinitely recommended: I have already made many recordings with it for instructional materials and videos.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |